Helix 12 & 10

  • Jacob J Preston
    Posts: 4
    #2216042

    What’s up everybody!?
    Quick question: I have two Helix 12’s on my dash, I want to take one off and replace it with a Helix 10 so I can use the Helix 12 with Mega Live in another location on my boat. Just wondering if the transducer/power cord from the Helix 12 will plug into the back of the Helix 10?

    Thanks for any information

    Karry Kyllo
    Posts: 1271
    #2216435

    That may be correct but the OP asked if the connectors are the same.

    Tom P.
    Whitehall Wi.
    Posts: 3528
    #2216463

    That may be correct but the OP asked if the connectors are the same.

    But if it does not work correctly, which I assume that is why he is asking.

    mojogunter
    Posts: 3303
    #2216708

    I ran into this. One older unit had a filter in the power cord, and the newer one did not, or the other way around. I can’t remember. Same plug into the unit. It would start to power up, but then crash before it booted up. I had to switch out the power cord to the one that came with the unit and all was good.

    Karry Kyllo
    Posts: 1271
    #2216789

    <div class=”d4p-bbt-quote-title”>Karry Kyllo wrote:</div>
    That may be correct but the OP asked if the connectors are the same.

    But if it does not work correctly, which I assume that is why he is asking.

    Why assume that? He never mentions having any problems. I’ve swapped different generation Helix power cables and transducers quite a few times without any issues as concerning the proper connections.

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.