HB 1198 and 958 on the console 2012 Ranger 620 PIC

  • TJB
    Cottage Grove, MN.
    Posts: 290
    October 13, 2011 at 1:39 pm #1295257

    All I can say is WOW. I sent my units to Ranger and they put them on. Off to the pond to test!

    walleyeben
    Albertville,MN
    Posts: 963
    October 13, 2011 at 2:32 pm #1001136

    Why didnt they put the big unit flat on the dash in back and the smaller units on the side in the front? Looks like one sick machine! Off to break in you go What did the dealer recomend for breaking on your XS?

    skeeter20
    Winnie/Grand Rapids,MN
    Posts: 902
    October 13, 2011 at 2:44 pm #1001142

    Nice. I would rather have the big graph on a ram then mounted in the dash too. But by the looks of it the 958 is kinda blocked by the 1198. Should be higher up and positioned so you can reach the keys. Here is a pic of Tommy Skarlis’s set up so you can see what I mean.

    Have fun breaking in the new boat

    riverwrat
    Hastings/ Northfeild,MN
    Posts: 179
    October 13, 2011 at 5:05 pm #1001207

    Better yet put em on the ROCK SOLID STABIL MOUNTS Vrey nice rig

    TJB
    Cottage Grove, MN.
    Posts: 290
    October 13, 2011 at 6:39 pm #1001249

    958 is main map so I won’t be doing too much with it. The 1198 can be turned but when in the drivers seat it’s not blocking at all. Hard to mount the 958 up any higher with a WT shield without having the 1198 in your lap.

    Ben,
    Frankies Marine recommended varied rpms and lots of warm up to temp. The motor will double up on oil the 1st 50 hours so just no constant besides idle.

    At the pond now off to play.
    Thx

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.