Troll Master problems

  • chappy
    Hastings, MN
    Posts: 4854
    #1264429

    Anybody have a problem with the speed varying on thier troll master? I’ve been trolling without it because it goes up,up,up,up, Then back to the original speed. 10 seconds later it does the same and so on and so on…… Any Ideas?

    John Gildersleeve
    Frazee,MN
    Posts: 742
    #806187

    Give trollmaster a call, they are very good with helping you out.

    robstenger
    Northern Twin Cities, MN
    Posts: 11374
    #806198

    Quote:


    Give trollmaster a call, they are very good with helping you out.


    x2. I had a problem once, they sent me out a whole new unit.

    marbles
    Northwest Wisconsin
    Posts: 60
    #806234

    I had a similar problem. I ended up re-routing the wires that go from the control box to the motor/servo on my T-8 (electric start/remote controls)because I think there was interference when they were near and not even touching the motor wiring. Trollmaster did sent out two different replacement servos and tested my control box, all free of charge. I have had zero problems since re-routing the wiring and replacing the servo. Good luck!

    Jami Ritter
    Hastings, MN
    Posts: 3067
    #806250

    Quote:


    Anybody have a problem with the speed varying on thier troll master? I’ve been trolling without it because it goes up,up,up,up, Then back to the original speed. 10 seconds later it does the same and so on and so on…… Any Ideas?


    Operator error????

    Dean Marshall
    Chippewa Falls WI /Ramsey MN
    Posts: 5854
    #806269

    Quote:


    Quote:



    Operator error????


    Install error Mr Ritter?

    Jami Ritter
    Hastings, MN
    Posts: 3067
    #806278

    Quote:


    Quote:


    Quote:



    Operator error????


    Install error Mr Ritter?


    aaahhh nooo, see he’s getting power….

    Smart AZZ

Viewing 8 posts - 1 through 8 (of 8 total)

You must be logged in to reply to this topic.