Boat License Sticker

  • jslsfish4u
    Cold Spring,MN
    Posts: 134
    January 6, 2009 at 2:10 am #1261065

    Anyone ever try removing the old sticker before applying the new one? If so, how or with what product was it removed with? I own a fiberglass boat. Or do you just go over the old one? Thanks Just wondering!

    sliderfishn
    Blaine, MN
    Posts: 5432
    January 6, 2009 at 2:11 am #734425

    There are some products out there that work well. I would try the good old fashion hairdryer first.

    Ron

    Eric Rehberg
    Eau Claire, WI
    Posts: 3071
    January 6, 2009 at 2:16 am #734427

    Like Ron said the hair dryer should do most of it. You may be left with a slight bit of sticky resin left but there is quite a few products out there that will take that off easy. Just have to be careful on what you use so it doesnt do any harm to the gel coat Good ole fashion elbow greese with a little water would be the safest bet there.

    Ralph Wiggum
    Maple Grove, MN
    Posts: 11764
    January 6, 2009 at 2:22 am #734429

    WD40 will get the goop off.

    igotone
    Posts: 1746
    January 6, 2009 at 2:26 am #734433

    Quote:

    There are some products out there that work well. I would try the good old fashion hairdryer first.

    Ron

    Then use Goo Gone works also for the sticky stuff

    t-ellis
    Colorado Springs, CO
    Posts: 1316
    January 6, 2009 at 4:25 am #734517

    Hair dryer as mentioned to get the stickers off and WD 40 to clean off the adhesive. Works easily and won’t harm the clear coat on nice finish.

    Jami Ritter
    Hastings, MN
    Posts: 3065
    January 6, 2009 at 2:01 pm #734562

    I guess I’m the lazy and just put the new one over the old one….

    Jami

Viewing 8 posts - 1 through 8 (of 8 total)

You must be logged in to reply to this topic.