MapCreate 6.3 Canada Topo by Lowrance

  • fireman731
    Miles, Iowa
    Posts: 574
    July 12, 2006 at 12:27 pm #1250771

    Well Monday my software got here after waiting over a month on backorder. But boy was it worth the wait! Got it all loaded up and put the map I needed on chips for the boat. The detail compared to the old 6.0 version is night/day difference. With 6.0 the best detail you could get in Canada was at about 20-30 miles, with 6.3 you go down to.015 miles and every thing is there. The maps seem to be right on when I laid my trails over the top. Water where it’s supposed to be and land where it needs to be. Well got to finish packing we leave in 36 hours.

    znak
    Byron, Mn. Rainy Lake
    Posts: 144
    July 12, 2006 at 5:17 pm #460052

    I am not familiar with this product. I have a place on Lake Wabigoon by Dryden. There are no chips out on this lake yet, would I be able to get a decent read out using this? I use a lowrance 104 and a 334c.
    Thanks for your help

    fireman731
    Miles, Iowa
    Posts: 574
    July 13, 2006 at 1:55 am #460199

    Just looked Wabigoon up, map shows a lot of shoreline detail, lots of islands and has the major bays marked. No depth readings but has topo elevations on the land. If I could figure out how to do a screen capture, I would show a picture of the detail.

    znak
    Byron, Mn. Rainy Lake
    Posts: 144
    July 13, 2006 at 12:53 pm #460265

    SOUNDS LIKE I SHOULD GET IT, THANKS.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.