state stickers

  • schulzee
    Duncombe IA
    Posts: 28
    February 28, 2005 at 2:21 am #1245804

    How do you get stickers of your boat with out hurting the paint?
    schulzee

    dougie
    Sobieski,Wi
    Posts: 456
    February 28, 2005 at 2:41 am #345940

    heat them up with a hair drier

    lundgeye
    Rochester, Minnesota
    Posts: 1209
    February 28, 2005 at 3:03 am #345950

    gently…keep checking, don’t overcook them or the paint will bubble as well. There is a “window” of opportunity when they are just warm enough to come off…

    Bob Carlson
    Mille Lacs Lake (eastside), Mn.
    Posts: 2936
    February 28, 2005 at 3:34 am #345960

    As was stated above……use of the low heat setting and what I have used is a soft piece of plastic as a scrapper. It works well, preventing any scatching!

    Steve Plantz
    SE MN
    Posts: 12240
    February 28, 2005 at 3:48 am #345969

    After you are done with the hair dryer if there is any left or it is sticky you can finish the job with Goo Gone

    davebmork
    Hayfield Mn
    Posts: 108
    February 28, 2005 at 5:16 am #345983

    POWER SPRAYER

    Cooner
    Hastings, MN
    Posts: 34
    March 1, 2005 at 1:09 pm #346278

    You can also remove the excess glue with WD40. Works great for removing tar off your vehicle too.

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.