Terrova mount w/ PD V2 motor?

  • Horsch32
    Avon, MN
    Posts: 25
    #1357800

    Anyone know if it is possible to use a powerdrive v2 motor with a terrova mount. I am getting tired of how hard the pd v2 is to deploy and thought that would be an option without having to buy a whole new motor. I think part of my problem is the hose clamp that holds the transducer on the motor just barely touches the part that holds it on. Any solutions to that since the mount most likely doesn’t work.

    eyekatcher
    Lakeville, MN
    Posts: 966
    #1406097

    either get a longer clamp
    or
    get a short clamp the same width and use them both.
    try to align all the mounting screws out of the area where it create a larger wake around the motor.

    Horsch32
    Avon, MN
    Posts: 25
    #1406107

    Never thought to use 2 clamps. I think I’ll just try to get a longer one. I was really hoping someone had tried to put a pdv2 into a terrova mount since the system is so much better.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.