Recommendation needed…Help!

  • orangewhip3x
    Blaine
    Posts: 109
    December 2, 2013 at 12:45 pm #1356248

    When I finally went to winterize my boat yesterday I trimmed the 200 Opti up and a horrible feeling overcame me. The bottom of the hydraulic cylinder leaked about 2oz of hydraulic fluid. It was nice and pink…no water in it. Appears to have a leaking seal. Does anyone have a rocommendation for a hydraulic cylinder repair service somewhere in the Twin Cities? Prefereably North Metro. Last time I had to have trim work done it cost me nearly $1K. Should be much cheaper in my mind. Your thoughts are much appreciated…keep in mind…the Trim I’m talking about is hydraulic

    mojogunter
    Posts: 3313
    December 2, 2013 at 12:49 pm #1368124

    Bring it to Rapid in Ham Lake, and request that Chad or Ernie repair it. Both are very good mechanics

    Aaron
    Posts: 245
    December 2, 2013 at 12:50 pm #1368126

    Quote:

    Last time I had to have trim work done it cost me nearly $1K. Should be much cheaper in my mind. Your thoughts are much appreciated…keep in mind…the Trim I’m talking about is hydraulic

    B-Bring
    O-Out
    A-Another
    T-Thousand

    big bummer, at least you found it now and not in the spring right before you head back out.

    jake-bohnsack
    Wright County Area
    Posts: 132
    December 2, 2013 at 2:03 pm #1368140

    Formula Propeller near Rogers, MN. Todd Hesse’s shop. Otherwise Grandpa Joe’s Marine- Joe Carlson in Harris, MN.

    tmyboy2001
    Lakeville, MN
    Posts: 282
    December 2, 2013 at 5:03 pm #1368185

    Hannay’s in St. Anthony. Ask for Don (service manager). Nate is one of their best mechanics. I’ve had lots of work done by them on several boats. Always fair and affordable.

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.