Yamaha 300 HP – Powerhead

  • Grouse_Dog
    The Shores of Lake Harriet
    Posts: 2043
    October 11, 2012 at 4:52 pm #1279181

    How much do they cost to rebuild – with a marine mechanic…?

    Anyone ever paid to have one rebuilt?

    Dog

    bigcrappie
    Blaine
    Posts: 4296
    October 11, 2012 at 5:14 pm #1104571

    Ouch that is going to hurt the wallet on a $20,000 motor

    James Holst
    Keymaster
    SE Minnesota
    Posts: 18926
    October 11, 2012 at 5:20 pm #1104572

    Quote:

    How much do they cost to rebuild – with a marine mechanic…?

    Anyone ever paid to have one rebuilt?

    Dog

    Is the motor still under warranty? That motor has only been out a couple years so I would think it would be covered unless it was a commercial use motor.

    If not under warranty… call Skeeter Boat Center for a quote. They have two platinum certified yamaha technicians on staff so should be able to steer you straight.

    crosby-stick
    Crosby MN
    Posts: 613
    October 11, 2012 at 8:02 pm #1104616

    I,m thinking it is a 300 HPDI James , if so then it depend how bad it is ?

    Grouse_Dog
    The Shores of Lake Harriet
    Posts: 2043
    October 11, 2012 at 8:05 pm #1104619

    2005 Motor – Lots of hours on it.

    Brent Yeakey
    Bloomer, WI
    Posts: 553
    October 11, 2012 at 8:34 pm #1104626

    Looking at just the powerhead alone retails for $3600, that does not include the labor or any other parts that may need to be replaced from the ruined engine.

    Neusch1
    Posts: 18
    October 12, 2012 at 2:00 am #1104664

    had to do a 200 hpdi 4 years ago at $6000 good luck

    James Holst
    Keymaster
    SE Minnesota
    Posts: 18926
    October 12, 2012 at 2:19 am #1104669

    Quote:

    I,m thinking it is a 300 HPDI James , if so then it depend how bad it is ?

    I totally spaced the HPDI – 300 HP motor. Sorry about that.

    AllenW
    Mpls, MN
    Posts: 2895
    October 12, 2012 at 2:23 pm #1104756

    Sounds like one of them winter DIY projects..

    Did a 75hp Johnson once, a 300 might be fun…….or not.

    You said lots of hours, the lower unit ok??
    Al

Viewing 9 posts - 1 through 9 (of 9 total)

You must be logged in to reply to this topic.