Mille Lacs Launch Conditions?

  • dave-barber
    St Francis, MN
    Posts: 2100
    September 28, 2007 at 5:03 pm #1288008

    Any resorts open up ice roads to vehicle traffic yet???

    BRING ON THEM WINTER PIGS!!!!

    desperado
    Posts: 3010
    September 30, 2007 at 12:23 am #612045

    with the water level so low and guys having trouble launching boats, it makes me wonder if we are going to be able to get our vehicles far enough down the boat ramps this winter to even be able to get onto the ice roads

    Bob Carlson
    Mille Lacs Lake (eastside), Mn.
    Posts: 2936
    September 30, 2007 at 11:37 am #612072

    Quote:

    with the water level so low and guys having trouble launching boats, it makes me wonder if we are going to be able to get our vehicles far enough down the boat ramps this winter to even be able to get onto the ice roads

    now thats a good one!!

    I just heard that the Red Door completed a drigging of their harbor and access out into the lake…..all the way out to the break is what I heard!!!

    George at Hunters Point Resort said he has plans to clean up his harbor/access again also.

    dave-barber
    St Francis, MN
    Posts: 2100
    September 30, 2007 at 1:34 pm #612080

    Quote:

    I just heard that the Red Door completed a drigging of their harbor and access out into the lake…..all the way out to the break is what I heard!!!

    Drigging? what is Drigging… cross between digging and dredging maybe?

    Bob Carlson
    Mille Lacs Lake (eastside), Mn.
    Posts: 2936
    September 30, 2007 at 3:06 pm #612105

    ops….I hope my wife don’t see that!!

    damn wish we had spell check……

    nurselake845
    Picard Point, Mille Lacs Lake
    Posts: 21
    October 1, 2007 at 8:47 am #612267

    Bob – that would be “I hope my wife doesn’t see that” for cryin out loud, I am everywhere!

    chomps
    Sioux City IA
    Posts: 3974
    October 1, 2007 at 2:37 pm #612341

    that there is funny!

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.