F250 question

  • Adam Steffes
    Posts: 439
    May 18, 2021 at 11:07 am #2037495

    Does anyone out there have the following:

    Stock suspension 2017-2019 F250 or F350 SRW with the PSD, with highest available factory spring rates, with 20” wheels and tires AND with a “cab high” topper from either ARE or Leer?

    I need to know what it measures from ground to the top of the topper at the highest point. Assume the highest point is right in the center back by the tailgate. All my website sleuthing and measurements indicate the topper will be roughly half an inch too high to make it in a 7’ garage door opening.

    Would appreciate a real world measurement.

    Thanks!

    Attachments:

    1. 3306BC0A-4719-4A39-8932-A30AC4487DE2-scaled.jpeg

    2. F504B2B1-5F5B-4A19-8043-27F5D526B91C-scaled.jpeg

    brueggemanate
    NW Iowa
    Posts: 44
    May 18, 2021 at 12:26 pm #2037513

    I have a 2019 f250 everything is stock wheels and lift. I have a flush to the cab topper on mine and I know I can go into a 7’ tall car wash. I will try to remember to check at home for an actual height measurement

    mark-bruzek
    Two Harbors, MN
    Posts: 3875
    May 18, 2021 at 1:56 pm #2037554

    Are your door ribs higher that your gasket?

    Adam Steffes
    Posts: 439
    May 18, 2021 at 2:48 pm #2037561

    The lowest door rib is about 88” from the floor in the full raise position, the door opening is 83.5” and of course the gasket hangs below that.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.