My eagle fishmark 500c is stuck on 60 feet. I went and checked the transducer when I got off the water and it was not clicking at all. It worked fine for the first couple hours out today. When I got home I hooked my fishmark 480 up to the same power and transducer and it started to click as if the transducer was working but the 500c would still not work. It was also still stuck on 60ft in my driveway. Anybody have a clue? 
Not sure what the reset procedure is on the Eagles but I would find out and give that a try first.
DO NOT upgrade to sofware version 1.7 for any reason.
From the sonar page in your owners manuel, press menu down to depth range push ent.
The depth control range scale appears press up or down to select a different depth range. A black bar highlights the selected range. when a new range is selected press exit.
If you wish to have the depth rangr in manuel turn off the auto depth range though i do not recommend this because the auto depth range will target the bottom 4-6 foot of water table.
This is found on page 48-49 of the x-135 owners manuel.
In the index it is in the d-section under auto depth range
depending on the type of owners manuel. If in doubt turn
owners manuel upside down and start over!
Good luck
Brian
You must be logged in to reply to this topic.
