Ranger Accessory Switches

  • walleyejohn
    Posts: 27
    #1235283

    Rigging a 619 that has digital switching with touch pads and I have a question. I know I could easily tie into the bus bar but, I would like to hook up electronics to an open accessory switch. What is the best way to tie into Ranger’s switch wiring? Currently there are open connectors. Your expertise is greatly appreciated.

    Thanks

    nick
    Lakeville, MN
    Posts: 4977
    #570677

    Well in my boat, I had and extra switch, it was already wired to power, I found a little power block in the dash, I just used that, and they were attached to the switch already.

    I can’t quite say this right… the switches are powered already, you just gotta find the correct little spade on the power block.

    Does that make sense?

    Atleast this how my 05 reata is.

    walleyejohn
    Posts: 27
    #570680

    That does make sense. I will need to do some more probing with the tester, switch & power block.
    Thanks

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.