Mercury Tune UP?

  • ToddJ
    Posts: 52
    #1234828

    I am hoping someone might know of someone who can complete a tune up on my 200 EFI and also see if there is anything that can be done to pick up a couple of miles an hour faster to the motor?

    dan-larson
    Cedar, Min-E-So-Ta
    Posts: 1482
    #534117

    I don’t know where you are in town, but I would highly recomend you call Extreme Marine up in Ham Lake. He did some work on Bobby’s Opti this last summer, I can’t remember the exact problem but I know it was bad. He had his boat back to him in less than a week and the price was way reasonable.

    He also did some work on my Yamaha two years ago, I asked for the fastest possible turnaround, he had it done in two days.

    I know this guy knows Mercs!!!!

    Cal
    Savage, MN USA!!!
    Posts: 66
    #534218

    If you’re in the south metro area, Shakopee Marine is the best Merc place around. They do all the work on my 175EFI which has been very little thankfully. What type of boat is the motor on? If it’s a bass boat, for setup tips you definitely want to check out Bass Boat Central- BBC
    Mac

    Brian Klawitter
    Keymaster
    Minnesota/Wisconsin Mississippi River
    Posts: 59992
    #534237

    Todd, I think you are in the Rochester area aren’t you.

    Al’s Specialty Marine.

    Check with Goosekiller Tim on that.

    gary_wellman
    South Metro
    Posts: 6057
    #534348

    I HIGHLY recommend, again HIGHLY recommend, that if you do your research on where to take motors too.

    Not every shop that sells mercury motors will know how to service your engine.

    I too heard of good things about Extreme Marine.

    ToddJ
    Posts: 52
    #534482

    Brian I grew up in Rochester and now live in Woodbury. Thank you

    Bob Bowman
    MN
    Posts: 3548
    #534501

    What Dan and Gary said. This guy is the best by far The drive to Ham Lake with your boat will be well worth the drive time. Best motor guy around in my book

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.