Lowrance LCX/Marcum Flasher Interference?

  • Trev
    Battle Lake, MN
    Posts: 965
    #1234818

    Just wondering if there would be an issure running these 2 units at the same time in my boat. The transducers would be mounted approx. 10″ apart. It worked with a fl-8, will it work with a LX-5? The lowrance is a x-19c.

    scottsteil
    Central MN
    Posts: 3817
    #532939

    I used to run a MarCum flasher and my Lowrance graphs together a few years ago. However, I did not have my transducers that close together. I have no problem running my Humminbird graphs and MarCum flashers together now. I get a little interference on the graph but it is still useable.

    Roddy
    Posts: 15
    #532975

    I recently was using my LX-3 and 332c in the same fish house. We were fishing 38′ of water. The lowrance did not have an issue, the Marcum however did pick up interference. I did have to send the Marcum back in however because it was a defective unit. Not sure if teh new unit will have interference issues or not.

    Trev
    Battle Lake, MN
    Posts: 965
    #533251

    Scott – what kind of interference do you get? Do you just get more clutter on your graph? How far apart are your transducers?

    scottsteil
    Central MN
    Posts: 3817
    #533364

    I don’t get any on the MarCum Flasher, just more clutter on the graph. You can adjust the sensativity on the graph and that helps. My ducers were 4 ft a part.

    I do run both a Humminbird and a MarCum off the trolling motor but usually I have the graph ducer turned off and use the flasher and just the GPS module.

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.