Marcum 825C question

  • Jack Naylor
    Apple Valley, MN
    Posts: 5668
    January 31, 2014 at 11:50 am #1355592

    I have a very lightly used 825C underwater camera.

    This last weekend I was up on Mille Lacs and

    hoping to use it some.

    When pressing the power on button, nothing would happen.

    Holding the power on, I would get the screen to come on,

    then when releasing the switch the screen would go off.

    I tried 3 different batteries from 90% charge to 100% charge, it did not make a difference, same thing happened.

    What do you think it could be, and if needs a repair who do you recommend.

    I’m in the south Mpls area.

    thanks,

    Jack

    Tom P.
    Whitehall Wi.
    Posts: 3528
    February 3, 2014 at 1:01 pm #1385536

    I had a 825c and had similar problems turned out to be the connection in the back from the battery??? May not hurt to check this connection over thoroughly.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.