I wanted to find one that holds 12 setups, I ended up making this one after thinking about how I wanted the rods to set in my office. This is made from a 12′ 1×4. 
Here it is in my office/fishing closet.
Looks Nice 
Well done, what did you use to hold the upper portion of the rod to the board? Clips of some sort? Thanks
Nice work!
That looks great, you should put a picture of a close up of the part that the rod actually is held by!
Very nice..
Looks good that’s my next project!
Big C,
that looks great. Well done too.
I’m just not sure I want my FW to see all my rods neatly in one place like that….I could be in trouble…. 
Quote:
you should put a picture of a close up of the part that the rod actually is held by!
St Croix sells them, the same ones everyone uses on the store displays. I was lucky and found some at Thorn Bros.
Nicely done.
Where did you find the clips that hold the rods on the upper part of your rack? I have lloked for the “rubber” type grips but not had too much luck finding those.
You must be logged in to reply to this topic.
