I messed around with some aluminum angle yesterday trying to make a mount for my elite 7. After a few hrs and multiple locations I came up with nothing that does not hinder operation of either something handle bar mounted,dash, or gas cap. Do any of you have a 7+ inch graph mounted on a Foreman? The way I have my Wheeler setup now the front rack will not work. Open to suggestions if anyone has a similar setup.
Have you looked at the variations that Ram Mounts offer? I’ve ran my H/bird 1198 on mine
I have a RAM mount attached to one of the arms on my Digger Auger Carrier I have mounted in the front. Granted it’s only a Helix 5 I have but it should work for anything bigger as well. Just make sure you go with 1.5″ or bigger balls.
Have you looked at the variations that Ram Mounts offer? I’ve ran my H/bird 1198 on mine
Did you run yours on a handle bar mount? I looked earlier this fall and had no luck finding anything larger then 1″ for a handle bar mount.
<div class=”d4p-bbt-quote-title”>Randy Wieland wrote:</div>
Have you looked at the variations that Ram Mounts offer? I’ve ran my H/bird 1198 on mineDid you run yours on a handle bar mount? I looked earlier this fall and had no luck finding anything larger then 1″ for a handle bar mount.
RAM Rail Base with “”Rust-Proof”” Stainless Steel U-Bolt & 1.5″” Ball for Rails from 0.5″” to 1″” in Diameter https://www.amazon.com/dp/B001HYN7G2/ref=cm_sw_r_cp_awd_KNTPwbYWM0B0W
Oops forgot to post this one as well.
RAM Mounts (RAP-400U) Small Tough-Claw with 1.5″ Diameter Rubber Ball https://www.amazon.com/dp/B00JQNRRVW/ref=cm_sw_r_cp_awd_IQUPwbTAMMQG8
You must be logged in to reply to this topic.
