Moore’s Bait? Bullheads in stock?

  • t-ellis
    Colorado Springs, CO
    Posts: 1316
    #1220139

    Do you have bullheads in stock at Moore’s Bait? If not when will be the earliest in the year you will have them in stock?

    david_scott
    Twin Cities
    Posts: 2946
    #548651

    No bullheads in stock yet.. no market for them right now.

    Bullheads will likely be in sometime in May.

    t-ellis
    Colorado Springs, CO
    Posts: 1316
    #548808

    I’ll be searching for them to use early season in April so if they can be found I would think there will be a market. I’ll check around and if nothing else will go catch some to use.

    mplspug
    Palmetto, Florida
    Posts: 25026
    #548809

    Do you live in Sartell? What exactly are you going to fish for using bullheads this early, especially that far north? Don’t take that question in the wrong tone, I am just curious.

    t-ellis
    Colorado Springs, CO
    Posts: 1316
    #548826

    Yes i live in Sartell however they are not for up here but rather i drop by Moore’s Bait on the way to Pools 3-4 or the MN River chasing flatheads. Also don’t count out the Upper Miss. above the Sartell dam for Channel Cats since i have caught many up to 12 lbs and found a dead 18-20 lbs Channel Cat floating in that stretch last summer so they are in there but cutbait is the answer for them of course.

    david_scott
    Twin Cities
    Posts: 2946
    #548831

    bullheads are hard to come by that time of year. Send me a pm when the time gets closer and let m know exactly what you need and I will see if I can make it happen.

    t-ellis
    Colorado Springs, CO
    Posts: 1316
    #548841

    You got it Dave! Thanks. I thought they would be tougher to get but I’m itching to get out.

    mplspug
    Palmetto, Florida
    Posts: 25026
    #548842

    I don’t doubt there are big channels up that way, I was just thrown off by the bullhead inquiry. If you have some early success, let us know!

Viewing 8 posts - 1 through 8 (of 8 total)

You must be logged in to reply to this topic.