Carbontex for pflueger

  • Zachary Farrow
    Posts: 7
    #1844129

    Hello everyone, first time posting here. I’ve been doing so searching and emailing with no real results. I’m looking to upgrade my reels with carbontex washer. With the pflueger reels, is it the 1.0 or the 0.5 carbontex I’m after? I haven’t torn any of the reels apart yet, but are the trion drag setups the same as the president reels? I have an assortment of both. Is there a go to company I couldn’t track down that will have all of this figured out and I just need to contact them? I’ve tried a few of the rod builders mentioned in previous posts on the search engine but I haven’t gotten a reply. My ice season has wrapped up for this year, looking for a nice upgrade/off season project. Thanks again everyone and love this site.

    Attachments:
    1. IMG_20181219_125251.jpg

    Zachary Farrow
    Posts: 7
    #1844159

    I did, I haven’t emailed them though. Suppose I’ll give it a shot. I looked at their list sheet and didn’t see any pflueger on the list but I’d guess they’ve done a few!

    Chris Messerschmidt
    Minnesota
    Posts: 615
    #1844302

    Call up John at Tuned Up Custom Rods. That’s where I got mine.

    Zachary Farrow
    Posts: 7
    #1844447

    Thanks for the input! Revo stx is the match for president/trion reels on smoothdrag. Got a reply back from smoothdrag first, so they’re getting my business!

    Mat Peirce
    Inactive
    SE Iowa
    Posts: 197
    #1845897

    Thanks for the input! Revo stx is the match for president/trion reels on smoothdrag. Got a reply back from smoothdrag first, so they’re getting my business!

    thats for baitcast…might wanna double check

    tucrs
    NW Metro
    Posts: 999
    #1845941

    Be careful as well some of the newer ones have thin washers that carbontext then do not work.

    If you are local I am sure I can help you out with them.

    John

    Zachary Farrow
    Posts: 7
    #1846509

    Thanks for the heads up guys, appreciate that. And indeed the list does specify spin cast…even though I asked specifically for spinning that was the reply. So back to square one. John, I’ll send an email soon. I’m out of state (Iowa) but do visit family up north a few times a year. Thanks again for the replies.

Viewing 8 posts - 1 through 8 (of 8 total)

You must be logged in to reply to this topic.