360 questions

I bought a used AS 360 TM ULTREX I have an i pilot link terrova, and a gen 2 helix9 I will modify the mount so the trolling motor not being an ultrex is irrelevant. I have been trying to get answers from humminbird customer service on what cables I need and I just can’t get anywhere. I have so far that I need an ethernet cable and the 5 port switch, but when I ask where the 3 pin cable that comes out of the 360 goes I have gotten 2 different answers.

Isn’t this a power cable? I’m assuming I need power to spin the 360 inards?

according the hbird diagrams it shows power going to the 360 transducer. but 2 agents have said no. I sent a picture of the cable and one said it goes to the trolling motor, and another says the 360 doesn’t need power?

thanks

The 360 needs a power connection to power the spinning transducer. The 3 pin is for power. The 8 pin is for the transducer and data.

Thanks Dave, do you know offhand what cable I would need to purchase to connect to the 360 to run to the battery?

.

Dave, I can’t find that part number anywhere. just to clarify this is a pic of the 2 cables coming out of my 360. the 3 pin is female and all power cables I see are also female. is this the same cable end you have? thanks

No, The pic i gave you is for the male portion of that cable that connects to the battery. I had to call half a dozen places a few years ago to find that part number. The cable was only available through humminbird.

Excellent, thanks for your help!

What are you guys using it for? And do you like it?