Hey guys.. I am going to be installing my new Garmin Livescope next week and am looking for some advice. I got the ECHOmap UHD 93sv with panoptics livescope. My question is, is the pre ran wiring in the bow sufficient to run power to both my screen and the “black box”? I don’t know what gauge that wire is. Any advice or tips would be awesome!
If you check your fuse panel,for the circuit you are tapping into, you will know what the total load for that circuit will be.
The fuse is set to protect the wiring.
Your individual unit fuses protect your sonars.
Hey guys.. I am going to be installing my new Garmin Livescope next week and am looking for some advice. I got the ECHOmap UHD 93sv with panoptics livescope. My question is, is the pre ran wiring in the bow sufficient to run power to both my screen and the “black box”? I don’t know what gauge that wire is. Any advice or tips would be awesome!
Run #10 tinned wire from the battery directly to a block in the bow. Hook the 93 & GLS10 (black box) to that block with a switch on the GLS10 power chord.
You must be logged in to reply to this topic.
