2015 Ranger 1880VS Transducer Install Question

  • Paul Codner
    Posts: 15
    April 5, 2019 at 1:41 pm #1848579

    I have a 2015 Ranger Angler 1880VS and I purchased a total scan transducer last winter for my boat. I am wondering how you guys are installing this on the transom. My old Javelin was a glass boat and I replaced electronics a few times so there were old transducer holes from that. I hate the idea of drilling holes in the hull so is anyone using those glue on Stern Savers or some other mounting block that you epoxy on? If so what are you using, where are you mounting them and how do you like them? Or should I just buy the screw on block?

    Thanks in advance for the input. I don’t have any pictures the boat is in storage still.

    Thanks
    Paul

    mojogunter
    Posts: 3313
    April 6, 2019 at 10:46 am #1848689

    Install a mounting board that way if you change later you don’t need to drill new holes in the glass. I have three on my present boat

    Attachments:

    1. 20190406_104723.jpg

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.